Mikes mount rear seadoo PWC camera/flag mount with bilge outlet

This is for the Rear mount for your Flag/umbrella/camera mount that also has the built in bilge pump outlet so there is no need to drill into your ski hull.

This is a really good informative video about the care of your mount https://youtu.be/lmLSSq4XD7Y?si=GcPSLW4tGSI3gHUX

PLEASE WATCH THIS VIDEO BEFORE ORDERING IT HAS IMPORTANT INFORMATION https://youtu.be/8Jha4-MaFdk

PLEASE ASK ANY QUESTIONS BEFORE ORDERING AS ALL SALES ARE FINAL, NO EXCEPTIONS

Breakage due to misuse including excessive speed, wave jumping, carrying passengers or accidental grabbing or pulling on flag pole etc is NOT replaceable under any circumstances.

The mount portion will accommodate up to a 25mm pole or selfy stick.

These are made from heat resistant material and colors are limited.. the video to install this rear mount is located here: https://youtu.be/dqCq5hR-cCc And if you choose to purchase this and install a bilge pump t a later time you can always go to your local hardware store and purchase a rubber cap for a 3/4" nipple and block the outlet off until needed. As mentioned, this is for a 3/4" bilge hose, if your hose is larger, 1", 1 1/8" etc you will need to purchase the appropriate reduced couplers etc from your local marine store!

The bilge pump used in the video is the Rule 360GPH purchased from BRP (seadoo). Other bilge pumps may be used.

Some of the pictures shown do not show the bilge addition and are solely to show the color.

The mount will work with the small linq cooler but any other size cooler or aftermarket rack may need to be removed before use.

seadoolife

seadoo

gopro

insta360